CHGQY - WOODPRIDE VARNISH FLAT, RV-406

  • MSDS: CHGQY
  • Manufacturer: SINCLAIR PAINT CO
  • Product Name: WOODPRIDE VARNISH FLAT, RV-406
  • National Stock Number: 8010-00N087389
Product Identification

Product ID:WOODPRIDE VARNISH FLAT, RV-406
MSDS Date:12/14/1988
FSC:8010
NIIN:00N087389
MSDS Number: CHGQY

Responsible Party
SINCLAIR PAINT CO
6100 S GARFIELD AVE
LOS ANGELES, CA 90040
US

Emergency Phone: 213-664-2121

Info Phone: 213-888-8888

Cage: 0U0K0

Contractor
SINCLAIR PAINT COMPANY
LOS ANGELES, CA 90040 US

Telephone: 213-888-8888

Cage: 0U0K0

Ingredients

STODDARD SOLVENT; (ALIPHATIC PETROLEUM DISTILLATE). BP

CAS: 8052-41-3

RTECS: WJ8925000

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM


NAPHTHA, HEAVY ALKYLATE; (ALIPHATIC PETROLEUM DISTILLATE).

CAS: 64741-65-7

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: MAY CAUSE EYE, NOSE, THROAT OR
SKIN IRRITATION. MAY CAUSE HEADACHE, NAUSEA, DIZZINESS, LASSITUDE
OR LOSS OF COORDINATION OR CONSCIOUSNESS. CHRONIC: NONE RECOGNIZED.
NONE OF THE INGREDIENTS OF T HIS PRODUCT APPEAR ON THE OSHA, NTP OR
IARC CARCINOGEN LISTES.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL: REMOVE TO FRESH AIR, GIVE ARTIFICIAL RESPIRATION IF
BREATHING HAS STOPPED. EYES: FLUSH EXPOSED EYES WITH FRESH WATER
FOR AT LEAST 15 MINUTES. SKIN: WASH EXPOSED SKIN WITH SOAP AND
WATER. CHANGE CONTAMINATED CLOTHING. INGEST: DO NOT INDUCE
VOMITING. KEEP HEAL LOWER THAN WAIST. ASPIRATION OF VOMITUS MAY
CAUSE CHEMICAL PNEUMONITIS. CALL MD.

Fire Fighting

Flash Point:105F,41C
Lower Limits:SEE INGS
Extinguishing Media:FOAM, DRY CHEMICAL OR CARBON DIOXIDE.
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP .
AVOID CONFINED SPACES UNLESS WEARING FULL BUNKER GEAR. WATER MAY BE
UNSUITABLE AS EXTING MEDIUM, BUT (SUPDAT)
Unusual Fire/Explosion Hazard:VAPS ARE HVR/AIR & MAY ACCUMULATE IN LOW
AREAS OF POOR VENT OR TRAVEL ALONG THE GROUND TO REMOTE IGNITION
SITES. CLOSED CNTNRS CAN BUILD UP PRESS & MAY (SUPDAT)

Accidental Release

Spill Release Procedures:REMOVE SOURCES OF HEAT, SPARK OR FLAME. WEAR
APPROPRIATE CLOTHING AND GEAR. CLEAN UP SPILLS IMMEDIATELY WITH
ABSORBENTS SUCH AS CLAY, SAND OR OTHER SUITABLE MATERIALS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:KEEP COOL, DRY & AWAY FROM HEAT, SPARK
OR FLAME (ALL IGNITION SOURCES). STORE IN A WELL VENTILATED AREA.
KEEP CNTNRS CLOSED & UPRIGHT WHEN NOT IN USE.
Other Precautions:AVOID EXCESSIVE PERSONAL EXPOSURE. GROUND & BOND ALL
TRANSFER CONTAINERS & EQUIPMENT. DO NOT WELD, DRILL, CUT OR GRIND
FULL, PARTIAL OR EVEN EMPTY CONTAINERS (RESIDUE &/OR VAPORS MAY BE
PRESENT). USE WITH ADEQUATE VENTILATION.

Exposure Controls

Respiratory Protection:AVOID EXCESSIVE VAPOR INHALATION. IF PEL OR TLV
IS EXCEEDED, USE A NIOSH APPROVED RESPIRATOR OR SCBA. USE A
MECHANICAL FITLER TO REMOVE SOLID AIRBORNE PARTICLES DURING SPRAY
APPLICATION.
Ventilation:GEN MECH VENT MAY PROVIDE SUFFICIENT VOLUME & PATTERN AIR
MOVEMENT TO KEEP EXPOS BELOW PEL & TLV. EXPLOSION- (SUPDAT)
Protective Gloves:NEOPRENE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIE FIGHT PROC: HELPFUL IN COOLING HOT SURFS & UNRUPTURED CNTNRS. IF
WATER MUST BE USED, USE WATER FOG (NOT A DIRECT STREAM OF WATER) AS
BURNING MATL MAY SPREAD &/OR FLOAT ON WATER SURF. EXPLO HAZ: EX
PLODE WHEN EXPOSED TO EXTREME HEAT. VENT: PROOF VENT IS RECOMMENDED
FOR FLAMMABLE MATLS.

Chemical Properties

Boiling Pt:B.P. Text:>300F,>149C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:0.85-0.91
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:67-71

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ACIDS AND BASES, SELECTED AMINES.
Stability Condition to Avoid:HEAT, SPARKS OR FLAME.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
UNIDENTIFIED ORGANIC COMPOUNDS.

Disposal

Waste Disposal Methods:PLACE IN NON-LEAKING CONTAINERS AND DISPOSE OF
IN ACCORDANCE WITH APPLICABLE LOCAL, COUNTY, STATE AND FEDERAL
REGULATIONS. BEFORE BEGINNING CLEAN-UP, REFER TO ALL SECTIONS OF
THIS MSDS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.